Tftp Error Messages On Portserver Ii - Digi PortServer II User Manual

TFTP Error Messages on PortServer II

If a TFTP error occurs while booting, the host returns an error message, which PortS-
erver II displays on the alphanumeric display on the front panel. This message will be
in the format Fn, where Fn can be one of the following:
F0
F1
F2
F3
F4
F5
F6
F7
If a TFTP error occurs:
1. Check that the remote host system supports TFTP.
2. Repeat the TFTP command.
3. If the problem reoccurs:
a. Press the arrow keys (< and >) on PortServer II's front panel to reboot from
internal Flash ROM
b. Repeat the configuration command set host to ensure that the host's IP
address, and the path and file name of the configuration file are correct. The
syntax for set host is given in the Command Reference Guide.
If the problem continues, you may have a system or network incompatibility that pre-
vents the use of TFTP.
90030500B
Error not defined, see error message (if any)
File not found
Access Violation
Disk Full or allocation exceeded
Illegal TFTP operation
Unknown transfer ID
File already exists
No such user
Remote Configuration Page 185