Radius Messages - Digi PortServer II User Manual

RADIUS messages

(Option=radius)
1) Radius: Callback not supported, access denied.
The user's RADIUS configuration specifies callback, which is not supported by
PortServer II.
2) Radius: Auth. only not supported, access denied.
The RADIUS server returned a service type of "Authorization only", which is not sup-
ported by PortServer II.
3) Radius: Service not recognized, access denied.
The RADIUS server indicated a type of service that PortServer II does not understand.
4) Radius: Protocol not recognized, access denied.
A Framed Protocol value other than SLIP or PPP was specified.
5) Radius: Routing value not recognized, access denied.
An undefined Routing value was indicated by the RADIUS server.
6) Radius: Compression value not recognized, access denied.
An undefined Compression value was indicated by the RADIUS server.
7) Radius: Login service type not recognized, access denied.
An undefined Login-Service value was indicated by the RADIUS server.
8) Radius: Attribute type <number> not recognized, ignored.
An attribute has been found that is not defined by the RADIUS specifications. This
attribute was ignored because "tolerate unrecognized attributes" has been turned on in
set radius.
9) Radius: Attribute type <number> not recognized, access denied.
An attribute has been found that is not defined by the RADIUS specifications. Access
was denied because "tolerate unrecognized attributes" has been turned off in set
radius.
Page 230 Troubleshooting 90030500B