Netcx Messages - Digi PortServer II User Manual

or invalid.
7) couldn't add to route table (invalid metric)
An attempt to add a route to the Route Table failed because metric was not 1 for a
direct host address, greater than 3 for a direct net address, or 0 for an indirect address.
8) couldn't add to route table (invalid address)
An attempt to add a route to the Route Table failed because the address is the same as
the Ethernet's IP address.
9) couldn't add to route table (invalid mask)
An attempt to add a route to the Route Table failed because the mask equals 0.
10) couldn't add to route table (invalid interface name)
An attempt to add a route to the Route table failed because the interface (WAN) name
is unknown or invalid.

NetCX messages

(Option=realp)
1) reset server <IP address> : <cause>
An error of this type is caused by a RealPort Driver violating the RealPort Protocol.
If <cause> is:
Port is out of range
Access to unopened port
Unimplemented open type
Received Illegal Packet type
2) Server setting socket failed
*Internal error*
90030500B
The error is caused by:
A RealPort Driver trying to access a port that does
not exist
A RealPort Driver attempting to cause an action on
a port that it had not opened.
A RealPort Driver sending an unrecognized open
request type.
A RealPort Driver sending an unrecognized packet
type.
Troubleshooting Page 215