A 29 Cycle G Bavarian Cream - Promag CUOCICREMA Series User Instructions

PROMAG
15 17
13
1
8
14
13
3
3
10 1 1
A 29.1
Visualize cycle G on display (see program check).
Press button (1) (cooking cycle start-up button).
18
Led (13) will come on.
Electrovalve will load water for 1 minute.
During loading time, the low speed "motor" (led 15 lit) and high speed
"motor" (led 17 lit) will start up at a distance of five seconds from one
another.
On terminating water loading (electrovalve on OFF position) relay and
resistance 1 are activated.
After five seconds relay and resistance 2 (only if 13G is ON).
During cooking cycle, it is possible to have a 5-second acoustic signal 12 G
(led 18 lit).
During signalling led 18 flashes.
Signalling may be interrupted with button (8) (led 18 off).
During the cooking phase high speed mixer may be manually excluded with
button (7).
At final cooking temperature 2G, electric resistances are disconnected and
the pause phase 10G begins.
Led 18 flashes.
A 29.2
First two digits show temperature variation on display.
Third digit shows program selected.
Fourth and fifth digits show first SET of achievement of started cycle.
On reaching programmed final cooking temperature 2G, electric
resistances are no longer active, led 13 flashes for the pause time at the
final cooking temperature 10G.
The last two digits on display start COUNT-DOWN of pause time in minutes.
On termination of pause time, low speed pre-cooling phase begins (led 13
off, led 14 on).
The electrovalve operates until final pre-cooling temperature 4G is reached.
At temperature 5G the refrigeration compressor comes on, turning off at
temperature 3G.
SET indicates temperature 3G.
When product temperature increases by 2°C with respect to SET 3G, the
compressor starts operating.
A 29.3
In order to extract product, open tap to dense mix position and press button
(10) (OFF), button (11) (last program set and activation of functions of all
buttons) and button (3) (low speed continuous mixing).
Press button (3) again: the machine remains in STAND-BY.
Low speed mixer stops.
By pressing button (3) again, the low speed mixer starts operating again.
To maintain product remained in cylinder press button (2).
When temperature exceeds 2°C with respect to SET 3G, the compressor
and low speed alternated mixer will start operating until reaching 3G.
USER INSTRUCTIONS
STARCREM 30/1 INV
A 29 - CYCLE G Bavarian cream
- STARCREM 60/1 INV
41
GB