Promag CUOCICREMA Series User Instructions page 28

STARCREM 30/1 INV
Assure that machine is perfectly grounded, as foreseen
by safety regulations in force.
It is necessary that this fundamental safety requisite is
respected: in the case of doubt, ask for a careful
control of the plant by professionally qualified people.
Check that plant electric power is suitable to the
maximum absorbed power of the machine.
In case of doubt, revert to a qualified person, who must
control that the plant cable section is suitable for
absorbed power of machine.
Do not touch the machine with either wet or damp
hands or feet
Do not use the machine barefoot
Do not use extensions in rooms destined for
bathrooms or shower rooms
GB Do not pull the feed cable to disconnect the machine
from mains.
A 17.2
In order to avoid dangerous overheating, it is
necessary to wind up the entire feed cable.
Before carrying out any maintenance operation,
disconnect machine from mains, using plant
disconnecting device.
In case of breakdown and/or poor functioning of
machine, disconnect the main disconnecting device,
abstaining from any attempt to repair or intervene
directly, reverting only to professionally qualified and
authorized personnel.
Eventual product repair will have to be carried out by
manufacturing company or by an authorized Service
Centre, only using original spare parts.
Machine safety could be compromised, if above
instructions are not observed.
A 17.3
Never utilize water to turn out fires occurring on electric
parts, but a dry powder fire extinguisher.
The machine must be turned off when not in use.
Do not modify protections and remove them only when
machine is no longer operative and disconnected from
mains.
Should you decide to no longer use this type of
machine, disconnect same by removing feed cable
from mains.
Discharge line must be in a position to resist a conti n uous
28
- STARCREM 60/1 INV
USER INSTRUCTIONS
temperature of 100° C and wel l secured to the drai n col l e ctor.
For cleaning operations, scrupulously follow
instructions laid down by manufacturer.
Do not block suction or dissipation grilles.
After having disconnected the machine, only qualified
personnel may have access to control panel.
When washing stainless steel, it is absolutely
PROMAG