A 10 Correct Use Of Product Dispensing Cock - Promag CUOCICREMA Series User Instructions

PROMAG
STARCREM 30/1 INV - STARCREM 60/1 INV
A 10 - CORRECT USE OF PRODUCT DISPENSING COCK
In order to use the product dispensing cock correctly,
the following must be carried out:
begin productive cycle after having carried out cleaning
operations indicated in specific paragraph.
Piston bush
However, remember that mechanical parts in contact with
food must be perfectly sterilized, whilst those in motion
Cock safety lock Liquid mix outlet
or sliding must be subsequently lubricated,
lock
using advised products or similar.
A - Check that guide rod, piston bush and 2 OR
Guide rod
seals are duly lubricated. Push piston guide rod bearing
Setscrew
against slide.
Tighten the dowel on the right-hand side with
special setscrew wrench.
B - Place cock safety lock in vertical position.
C - Place liquid mix outlet lock in downward position.
GB
D - Assemble piston group onto guide rod with piston bush.
Centering of bush with rod should be carried out carefully,
OR seals
Piston
thereby avoiding any damage to bush during introduction,
wearing out external edges of same.
E - Screw setscrew until contact is made with guide rod.
Assembled cock
A 10.2
Cock disassembly
Repeat previous operations in opposite sense.
A 10.3
Cock closing
A - Push the piston group towards the dense mix outlet.
The movement direction must be perpendicular to outlet.
IN NO WAY MUST GUIDE ROD OR PISTON GROUP BE FORCED
IN DIFFERENT DIRECTION, as disalignment of guide could be
caused, with consequential erroneous centering of piston in outlet.
B - Introduce piston into the outlet with a smooth movement, avoiding
that any metallic parts of the two components come into contact with
one another. Push piston until reaching stop.
C - Lower the cock safety lock.
D - This will guarantee closing position, also in the presence of strong
mixing vibrations in the cylinder towards outside.
Working surface
USER INSTRUCTIONS
20