A 15 Protection Measures For Dangerous Machine Areas; A 16 Risks Information - Promag CUOCICREMA Series User Instructions

STARCREM 30/1 INV
A 15 - PROTECTION MEASURES FOR DANGEROUS MACHINE AREAS
A 15.1
The machine is equipped with a casing, preventing
access to internal part of machine, together with
moving parts.
Above casing is fixed with screws.
Casing (fixed with screws) may only be removed by
qualified personnel and authorized by Promag.
A 15.2
Manual access to cylinder outlet is very difficult and
nevertheless it is only possible when cock has been
disassembled or is in open position.
The distances of the liquid mix and dense mix outlets
from the lateral surface of the cylinder and therefore
from the scraping blades and relative low speed shaft
GB
is considerable, thereby preventing access of body
parts and avoiding above-mentioned dangers.
A 15.3
A 16 - INFORMATION ON OTHER RISKS IMPOSSIBLE TO ELIMINATE,
DESPITE MEASURES ADOPTED BY DESIGNER
Other risks involved using the machine are:
A 16.1
Danger of entangling and dragging.
Please note that it is absolutely forbidden to come
into contact with mobile parts inside the cylinder (high
speed mixer shaft, low speed mixer shaft) whilst the
machine is functioning, with any object whatsoever or
part of the body, as this could result in jamming,
crushing and/or cutting.
Danger exists if, for imprudent cleaning operations
with cleaning rods or similar and with the machine still
in operation, one attempts access to cylinder through
the liquid mix outlet or through the cylinder pipe
union, with tap either disassembled or open. In case
of danger, press the STOP button.
A 16.2
Dangerous pressures
The cooling system still remains under pressure
even when the machine is off.
Before carrying out maintenance operations on same,
eliminate this type of risk.
26
- STARCREM 60/1 INV
USER INSTRUCTIONS
Access to high speed mixer shaft and low speed mixer
shaft is possible only by lifting the front and/or rear half-
lid and/or motor bearing. With above operations, the
three safety magnetic microswitches interrupt all
machine operations, stopping rotation motion of same.
A 15.4
During cleaning phase of two shafts, the motor bearing
is lifted in vertical position.
It is impossible for same to fall backwards, thereby
crushing hands or upper limbs of operator, as in this
position the motor bearing lock device is automatically
activated, as previously described.
A 16.3
Thermal danger
Please note that on water and cooling systems both hot
and cold mechanical parts exist, protected by special
casings.
Besides, any contact with same is absolutely
forbidden, thereby avoiding burning risks.
Danger exists in the case of repair and/or with internal
inspection of machine when same is still functioning or
recently turned off. (Remember that these operations
must be carried out by qualified personnel, authorized
by Promag).
Danger also exists when processing mixes whose final
heating temperature is high and when cylinder lid is
opened for product inspection.
If user is near the cylinder, steam produced by liquid
mix may hit his face, causing burning. Danger also
exists if hands or other parts of the body are introduced
into the mix. It is absolutely forbidden to introduce
hands or any other part of the body into the hot mix. It
is absolutely forbidden to bring face or other parts of
the body near the cylinder.
In case of danger, press the STOP button.
PROMAG