A 25 Cycle A Pastry Cream - Promag CUOCICREMA Series User Instructions

PROMAG
STARCREM 30/1 INV - STARCREM 60/1 INV
A 24.3
While cooking, there are 3 steps in which we can change the speed,
P0
namely:
- P0
- P1
- P2
Once at the 1st temperature set, where you may wish to change the
9
speed, press the button RESET (9) and P0 will blink on the display; with
buttons (+/-) it is possible to change P1, P2
.
A 24.4
Press again RESET (9) and V1 will blink on the display; with buttons (+/-) you
V1
can change the speed.
The speed is stored only when no futher changes are made for 5".
In order to modify the speed in cooking pause, vary P3.
P4, P5, P6 are steps where we can change the speed during cooling cycle.
P7 to be used to change the speed in storage mode.
GB
Changes canot be seen.
9
A 25 - CYCLE A Pastry cream
18
A 25.1
15
Visualize cycle A on display (see program check).
17
Press button (1) (cooking cycle start-up button). Led 13 will come on. Electrovalve
13
will load water for 2 minutes.
1
During loading time, the low speed "motor" (led 15 alight) and high speed "motor"
(led 17 alight) will start up at a distance of 5 seconds from one another.
Once water loading has finished, (electrovalve in OFF position), the relay of the first
resistance is activated.
After 5 seconds, the relay of the second resistance.
Activation of ringing device 12 A (temperature alarm during cooking).
Led 18 is alight.
At programmed temperature 6A (temperature at end of high speed mixing), the high
speed "motor" turns off.
7
Above may occur also manually, by pressing button (7) (ON/OFF high speed motor
button). Led 17 is off.
A 25.2
14
15
During cooking cycle an acoustic signal 12A is possible, lasting for five seconds, for
13
18
16
the introduction of ingredients.
Activation of this acoustic signal is visualized by led 18.
Above may be cancelled by pressing button (8). Led 18 is off.
On reaching final cooking temperature 2A, pause time starts at final cooking tempe-
rature 10A. The electric resistances are disactivated.
The display in position of fourth or fifth digit (figure or letter) proceeds with a COUNT-
DOWN (backwards) in minutes until end of pause.
Once time has expired (00), the display SET visualizes temperature 3A of cycle end
[through button (12)].
The electrovalve opens for pre-cooling until final pre-cooling 4A temperature. Led
8
(14) lights up and led (13) turns off.
USER INSTRUCTIONS
34