A 17 Recommendations On Prevention Measures To Be Adopted - Promag CUOCICREMA Series User Instructions

PROMAG
A 16.4
Danger of cutting, entangling and crushing
During washing and cleaning operations, the motor
bearing is lifted and placed in vertical position. As
already mentioned, there is no danger of same falling
and crushing hands or upper limbs, as in this position
the motor bearing lock device is automatically
activated, as described above. Danger still exists,
however, if, during opening of motor bearing, operator
fails to take a firm grip of same, owing to wet hands or
similar, or lacks sufficient strength.
In this case, the motor bearing would fall on the
cylinder plane, hitting any object in its way, causing
crushing, cutting and entangling between itself and the
edge of the cylinder, in addition to cylinder plane.
It is absolutely forbidden to place the machine in an
environment unsuitable for its appropriate use.
It is absolutely forbidden to move the machine and/or
its components in an irregular manner, thereby
jeopardizing its stability and reliability.
In case of danger, push the STOP button.
A 16.5
Danger also exists when approaching the machine
(especially with motor bracket open) with magnetic
materials, as same would interfere with safety magnetic
microswitches located under the two cylinder half-lids
and under the right shoulder of the motor bearing. In
this case, if the machine were operating, the two
A 17 - RECOMMENDATIONS ON PREVENTION MEASURES TO BE ADOPTED
A 17.1
Safety regulations.
In order to maintain the machine in a perfect state
and guarantee a safe operation for user, we advise
that following regulations are scrupulously followed.
This machine must only be used for the purpose for
which it has been originally designed.
Any other use is to be considered improper and
therefore dangerous.
During handling, loading and unloading of machine, be
very careful in choosing lifting points.
Do not leave machine exposed to atmospheric agents
(rain, sun, etc.).
Do not permit machine to be used by children or
STARCREM 30/1 INV
motors would start up, causing the respective shafts to
rotate, dragging anything in contact around with them.
It is absolutely forbidden to approach the machine with
magnetic materials or interfere with safety magnetic
switches on purpose.
In case of danger, press the STOP button.
A 16.6
Dangerous electric voltage
During repair and/or maintenance operations,
(operations nevertheless permitted only by qualified
personnel, authorized by Promag), it is possible that
technician needs access to control panel, motor
compressor, motors or any other electric or
electromechanical component.
Danger exists if these operations are carried out without
having previously cut off electricity from mains, using a
special disconnecting device provided for during
machine installation, or even worse, when the machine
is in operation.
It is absolutely forbidden to gain access to electric and/
or electromechanical parts, without having previously
turned off machine with special disconnecting device.
In case of danger, press the STOP button.
inexperienced persons.
Machine must not be used by untrained personnel.
Maintain machine in perfect operating state, always
utilizing the various protections provided for, having
periodical maintenance carried out by professionally
qualified personnel.
Before connecting the machine, control that plate data
corresponds to that of electric and water distribution
network, (the plate is situated at the rear part of the
machine).
USER INSTRUCTIONS
- STARCREM 60/1 INV
27
GB