Writing Parameters To The Cpu - Mitsubishi Electric Melsec QJ71LP21 Reference Manual

5 PARAMETER SETTINGS

5.10 Writing Parameters to the CPU

5 - 42
To enable the network parameter settings, they must be written to the CPU using the
Write to PLC function of GX Developer.
The PLC parameters are written as well when the network parameters are written.
To write the parameters to a programmable controller of other station than the one that
connects GX Developer via the MELSECNET/H, change the specification of the
connection destination of GX Developer.
For more information on how to use this function, refer to the GX Developer Operating
Manual.
(1) Select the Write to PLC function
(2) Select the parameter as a file to be written, and then execute.
MELSEC-Q
5 - 42