4
SETUP AND PROCEDURES BEFORE STARTING THE OPERATION
4.2.2 QJ71BR11
STATION NO.
10 10s unit
10
1
4 - 5
(1)
Indicator LEDs
Same as the optical loop system. (Refer to Section 4.2.1.)
(2)
Station number setting switch
Used to set the station number of the network module. (Factory default: 1)
Setting
0
1 to 32
1 1s unit
33 to 64
65 to 99
POINT
(1) Station numbers cannot be duplicated in the same network.
(2) Any station can be set as the control station as long as the station number is
within the setting range.
(3) The station number can be set randomly. Note that stations with no number
assignment must be set as reserved stations.
(4) When setting, use a station number within the range set to "Total stations"
parameter of network parameter.
Description
Setting error
(The ERR. LED turns on.)
Station number 1 to 32
Setting error
(The ERR.LED will not turn on.)
Setting error
(The ERR. LED turns on.)
MELSEC-Q
4 - 5