3
SPECIFICATIONS
Product name
Solderless terminal
Tool dedicated for
solderless terminal
Solderless terminal
Tool dedicated for
solderless terminal
Solderless terminal
Tool dedicated for
solderless terminal
1: If a shielded or FG wire is crimped to a solderless terminal using the CRIMPFOX UD6-4 or CRIMPFOX
UD6-6, the wire may not be connected to the terminal block depending on the condition of cross section
of the solderless terminal after crimping.
3 - 12
(2) Connection of shielded twisted pair cables and terminals
This section explains connecting method of terminal and cable.
(a)
Applicable solderless terminals and crimping tools
Model
FA-VTC125T9
FA-NH65A
TE0.5-10
NH-79
AI0.5-10WH
CRIMPFOX UD6
CRIMPFOX UD6-4
CRIMPFOX UD6-6
CRIMPFOX ZA3
(b)
Stripping the cable end
Use an appropriate tool to crimp the solderless terminal. (Refer to (a) in this
section)
For details of the crimping method, refer to the manuals for the solderless
terminal or crimping tool used.
In the example, a crimping tool "FA-VTC125T9" manufactured by
Mitsubishi is used.
1) Strip the cable jacket by 5.5mm to 6.5mm.
2) Place the terminal in the correct place (in the end) of the locator.
3) Insert the terminal until it reaches to the locator.
4) Insert the stripped cable into the terminal and crimp it.
Manufacturer
For inquiries and orders, please contact
your local Mitsubishi Electric Engineering
Co., Ltd representative.
For inquiries and orders, please contact
your local NICHIFU TERMINAL MFG. Co.,
Ltd representative.
For inquiries and orders, please contact
your local Phoenix Contact representative.
MELSEC-Q
Remarks
2
0.3 to 1.65mm
2
0.3 to 0.5mm
2
0.5mm
1
1
3 - 12