Table of Contents
Advertisement
2. GENERAL
(A) Bolt hole (bolts, nuts)
3. Installing circlips
• When installing the circlip, assemble the circlip's
angular side (3) toward the side that receives force
(4) as shown in the figure.
(1) Circlip
(2) Rounded side
(4) Side that receives force
(5) Force
4. Handling liquid gasket
• Use the specified liquid gasket.
2-2
(B) Screw hole
(3) Angular side
(A) External circlip
(B) Internal circlip
GENERAL WORKING PRECAUTIONS
• When using liquid gasket, fully remove the old
gasket and grease or oil.
• When applying liquid gasket, apply it on the joint
surface with a thickness of 3.0 to 5.0 mm (0.12 to
0.13 in.) without making any gaps.
• When applying liquid gasket near the bolt hole (2),
apply it in the inner side.
• If there is a risk of oil leakage or if the hole goes all
the way through when applying liquid gasket near
the dowel pin (3) hole, apply it in the inner side.
If there is no concern of oil leakage, apply it on the
outer side.
• Reassemble within 15 minutes after applying; wait
for 30 minutes or more then fill with oil.
(1) Application route
(2) Bolt hole
(3) Dowel pin
(A) Correct
(B) Incorrect
5. Replacing O-rings
1. Remove the burr and clean the O-ring groove.
2. Lubricate the O-ring. Do not apply any grease to
the floating seal.
3. Put the O-ring in the groove.
NOTE
• Do not twist the O-ring.
• Remove the burr to avoid damage on the O-
ring caused by the burr.
3. Installing circlips
(a) 3.0 to 3.5 mm (0.12 to
0.13 in.)
(b) 3.0 to 5.0 mm (0.12 to
0.19 in.)
05-E4B SERIES,05-E4BG SERIES
KiSC issued 03, 2023 A
Advertisement
Table of Contents
