067: St.ep Tone+Trml (Stereo Ep Tone+Tremolo) - Korg Krome Parameter Manual

067: St.EP Tone+Trml (Stereo
EP Tone+Tremolo)
This faithfully simulates the preamp section and vibrato
(tremolo) effect from a famous model of tine‐type electric
piano.
a Volume 0...100
–10.0...+10.0 Sets the high-frequency boost or
b Treble
c Bass –10.0...+10.0
Vibrato Switch On, Off
Src Off...Tempo
d
Toggle,
Sw
Moment
Vibrato
1...100
Intensity
e Src Off...Tempo
Amt –100...+100
Vibrato
00.0...100
Speed
f Src Off...Tempo
Amt –100...+100
Dry, 1 : 99...
Wet/Dry
99 : 1, Wet
g Src Off...Tempo
Amt –100...+100
d: Sw
When this is set to Toggle, the Vibrato Switch will alternate
between on and off. For instance, if vibrato is off, and Src is
assigned to a footswitch, the first press will turn on the
Vibrato, and the next press will turn it off again.
Momentary means that the change happens only while the
controller is enabled. Continuing the example from above,
when the footswitch is pressed down, the Vibrato will turn
on; when the footswitch is released, the Vibrato will turn off
again.
Src lets you switch to the opposite of the programmed
setting. For instance, if vibrato is on, and the Sw is set to
Moment, then pressing down on the footswitch would turn
off the Vibrato.
If you set modulation source to use a continuous controller,
such as the Joystick, values of 0‐63 are as if the switch was
off, and values of 64–127 are as if the switch was on.
Finally ‐ note that the assignable switches, SW1 and SW2,
can themselves be set to either moment or toggle modes,
and these settings are reflected by the switch LEDs.
Individual parameter settings, such as the vibrato on/off and
Sw, do not affect the LEDs.
So, if you're using SW1 or SW2 as the modulation source, it's
best to set the Sw to Moment, and then just let the switch
itself determine the momentary/toggle behavior.
288
Sets the volume level of the
preamp
cut.
This controls the low-frequency
boost or cut.
Switches Vibrato on/off
Selects a modulation source for
Vibrate on/off
Selects the switching mode for
the modulation source that
switches the Vibrate on and off
p.288
Sets the intensity of LFO
modulation
Selects a modulation source for
Intensity
Sets the modulation amount for
Intensity
Sets the LFO speed
Selects a modulation source for
Speed
Sets the modulation amount for
Speed
Sets the balance between the
effect and the dry input
Selects a modulation source for
Wet/Dry
Sets the modulation amount for
Wet/Dry