Korg Krome Parameter Manual page 353

LFO Frequency (Prog 5–1a)
The frequency of LFO 1, 2 or Common LFO can be
controlled by the EG, keyboard tracking, controllers, or
tempo etc.
You can also use the LFO2 frequency to modulate LFO1, or
use the Common LFO frequency to modulate LFO 1/2.
If Intensity is set to a value of 16, 33, 49, 66, 82, or 99, the
corresponding frequency can be multiplied by a maximum
of 2, 4, 8, 16, 32, or 64 times (or divided by 1/2, 1/4, 1/8, 1/16,
1/32, 1/64).
• Select JS +Y:CC#01 for AMS, and set Intensity to +16.
When you move the joystick in the +Y direction, the LFO
frequency will be increased by a maximum of 2 times. If
you set Intensity to –16 and move the joystick in the +Y
direction, the LFO frequency will be decreased by up to 1/
2.
LFO Frequency AMS Intensity (Prog 5–1b)
You can use the EG, keyboard tracking, controllers, or
tempo etc. to control the intensity of the AMS that controls
the frequency of the LFO 1, 2, or Common LFO.
For example if you're using the pitch EG to modulate the
LFO frequency, you could use a separate AMS to control the
depth of this effect.
• Set AMS to a controller such as SW 1 or 2, so that the
pitch EG will lightly control the LFO frequency when the
switch is off, and more deeply when the switch is on.
LFO Shape (Prog 5–1a)
You can use a EG, keyboard tracking, controllers, or tempo
etc. to control the shape of the LFO 1, 2, or Common LFO
waveform. You can also use the LFO2 frequency to
modulate LFO1, or use the Common LFO frequency to
modulate LFO 1/2.
• You can control the LFO waveform by setting AMS to a
controller such as JS+Y, and operating the controller when
desired.
Common LFO Reset (Prog 5–10a)
You can use a controller or tempo etc. to reset the Common
LFO.
• By setting AMS to Gate 1, you can make the Common
LFO reset when a note is played from a state in which all
notes are off. For example, this will ensure that a filter
sweep always starts from the same place.
• You can set AMS to a controller such as JS+Y: CC#01, and
operate the controller when you want to reset the LFO.
Alternate Modulation Sources (AMS)
345