6-2: Track View - Korg Krome Parameter Manual

Sequencer mode
6–2: Track View
6–2a
6–2b
6–2c
Here you can edit MIDI tracks 1–16 and the master track.
This page provides an overall view of each track's data such
as note, velocity, and control change data.
In the track view area you can drag to select track and
measure regions, and move, copy, or erase tracks. You can
also edit in measure units.
You can also use various menu commands to edit the region
you selected by dragging.
6–2a: Location, Meter, Tempo, Tempo
Mode, Song Select, Track Select,
Reso, RPPR
6–2b: Track Info
("0–1(2)a: Location, Meter, Tempo, Tempo Mode, Song
Select, Track Select, Reso, RPPR" on page 109)
("2–3: EQ T01–08, 2–4: EQ T09–16" on page 124)
Track Select [Track01...Track16, Master Track]
Here you can select the track to edit. This Track Select
setting will change when you press the track view area.
When the track changes, the display will briefly turn blue.
The highlighted portion that shows the selected region of
the track view area will also change when you change the
track here.
Track name indication
Control message name indication
( Track View Setup)
Track View area select
The bar at left indicates the four
tracks shown in the track view
area (in this example, tracks 1–4).
Scroll button
Setup
Press this button to open
the Track View Setup dialog
box.
( Track View Setup)
138
6–2
Menu
Location bar
Note events
Displays note events
in a one-octave range
( Track View Setup)
Velocity indication
( Track View Setup)
6–2c: Track View Area
Track View Area
This shows event information for each track, such as note,
velocity, and control change data. (see illustration below)
The highlighted measures are those that will be edited. The
region is indicated by the FROM MEASURE and TO END of
MEASURE fields in the upper part of the screen.
You can move, copy, or delete measures and tracks in units
of one measure.
Note: You can't specify a range of measures unless a tool in
the box tool is selected.
Track View Area Select
This shows track information for the track view area. The
bar at the left indicates the four tracks shown in the track
view area. The highlighted track number is the track that
will be edited.
The track display region will change when you touch the
track number.
In the Track View Setup dialog box you can change the order
of the tracks.
Scroll buttons
• These scroll the tracks or measures shown in the track
view area. Press the scroll button in the direction that you
want to move. You can also scroll by pressing inside the
track view area and dragging toward the outer edge of
the button.
Tool box
Start point select tool
Use this to specify the starting measure (FROM MEASURE)
of the range of measures you want to edit.
Choose this tool, and then press a measure in a track to
specify the starting measure (and the track). Continue
holding down the starting measure, drag to the right, and
release at the end of the desired selection. While dragging,
you can drag across a scroll button to scroll through the
measures while maintaining the selection.
If more than one measure is selected even though you
actually wanted to select only one measure, simply continue
pressing for approximately one second; the single measure
you're pressing will be selected.
Indicate the selected region. Linked
with the identically-named parameter
of the Track Edit page.
Pattern
Selected region Scroll button
Track view area
Scroll button
Tool box
Displays the values for the
control message name
indicated in the left of the
screen ( Track View Setup)