Korg Krome Parameter Manual page 226

Global mode
Update System Software
Update System Software is available on the Basic Setup
page.
Here, you can update the KROME system.
You can download the latest system file onto your computer
from the Korg website (http://www.korg.com/). For details,
please see the Korg website.
Before you begin the system update, you should back
up your important data on an SD card.
1. Insert the SD card containing the system file into the
SD card slot of the KROME.
Note: For details on how to copy the system file to your SD
card, please see the explanation on the download page of
the Korg website.
2. Access the Global P0: Basic Setup page.
3. Select "Update System Software" to open the dialog
box.
4. Press the OK button to execute the update.
A dialog box will ask you for confirmation. Press the OK
button to begin updating the system software.
Note: If an error message of "File/path not found" appears,
press the OK button and proceed again from step 1.
While the system is being updated, do not touch the
KROME' switches, and never turn off the power. If the
power is accidentally turned off while the system is
being loaded, the KROME may become inoperable. If
this occurs, please contact your local Korg distributor.
5. When the update has been completed, a dialog box
with the following message will appear.
The system update has now been installed. To complete the
process, you must now restart the KROME. Please turn the
power off, and then on again.
6. Power-off the KROME. Wait for several seconds, and
then turn the power on again.
After you turn the power off, wait for several seconds
before you restart the KROME.
The system version number is shown in the lower center of
the opening screen. Verify that it matches the new system
software version.
218
Dump:
Dump Program
Dump Combination
Dump Drum Kit
Dump Arpeggio Pattern
Dump Global Setting
Dump Sequencer
Dump Drum Track Pattern
These commands are available on the MIDI page.
These commands allow the KROME internal data to be
transmitted to another KROME, MIDI data filer, or
computer in the form of MIDI System Exclusive data.
Select the desired command (please see the following table),
and a dialog box will appear.
Then, select the bank or timbre etc. of the data to be
dumped, and press the OK button.
Programs of all banks, programs of one
Dump Program
bank, one program
Dump Combinations of all banks, combinations of
Combination one bank, one combination
Dump Drum Kit All drum kits, one drum kit
Dump Arpeggio
All arpeggio patterns, one arpeggio pattern
Pattern
Dump Global Global settings (except for the Drum Kits
setting and Arpeggio Patterns of Global mode)
Dump Sequencer All song data and cue list data
Dump Drum Track All drum track user pattern, one drum track
Pattern user pattern
Sending SysEx data dumps
Do not touch the KROME's switches or turn off the
power while SysEx data is being transmitted.
Sending a data dump
1. Connect the KROME to the device that will receive the
data dump.
If you want to transmit the data to a computer that is able to
receive SysEx messages, connect the KROME's USB
connector to your computer's USB connector.
If you want to transmit the data to another KROME or to a
MIDI data filer, connect the KROME's MIDI OUT connector
to the MIDI IN connector of the receiving device.
2. Select Global P1: MIDI page.
3. The following illustration shows the dialog box that
will appear when Dump Program is selected.
If To dump one bank select Bank, or to dump one program
select Single.