Configuring Port Functions; Configuration Prerequisites; Configuring Static Ports - H3C S5500-SI Series Manual

Operation Manual – Multicast Protocol
H3C S5500-SI Series Ethernet Switches
Configure
aging time
Configure member port
aging time

1.4 Configuring Port Functions

1.4.1 Configuration Prerequisites

Before configuring port functions, complete the following task:
Enable IGMP Snooping in the VLAN
Before configuring port functions, prepare the following data:
Multicast group and multicast source addresses
Whether to enable the fast leave feature
Whether to enabled IGMP report suppression

1.4.2 Configuring Static Ports

If the host attached to a port needs to receive multicast data addressed to a particular
multicast group or from a particular multicast source/group, you can configure this port
to be a static member port of that multicast group or multicast source/group.
In a network with a stable topology structure, you can configure router ports of a switch
into static router ports, through which the switch can receive IGMP messages from
routers.
Follow these steps to configure static ports:
To do...
Enter system view
Enter
the
corre
spon
ding
view
Configure a static
member port
Configuring a static
router port
To do...
igmp-snooping
router port
router-aging-time
interval
igmp-snooping
host-aging-time interval
system-view
Enter
interface
Ethernet
interface-number
port view
Enter port port-group { manual port-group-name
group view | aggregation agg-id }
igmp-snooping
group-address
source_address ] vlan vlan-id
igmp-snooping
vlan vlan-id
Chapter 1 IGMP Snooping Configuration
Use the command...
Use the command...
interface-type
static-group
[ source-ip
static-router-port
1-9
Remarks
Optional
105 seconds by default
Optional
260 seconds by default
Remarks
—
Use either
command
Required
Disabled by default
Required
Disabled by default