Intermec MobileLAN 21 Series System Manual page 99

The following table explains each parameter.
Parameter Explanation
Multicast Flood Determines the flooding structure for inbound multicast frames with
Mode unknown destination addresses.
Universal Allows any wireless end device to communicate with any
other wireless end device.
Hierarchical Allows wireless end devices to communicate with nodes
on the primary LAN but not with other wireless end devices.
Disabled Prevents flooding.
Multicast Outbound This parameter only applies to 802.11b and OpenAir radios. If
to Terminals multicast flood mode is not disabled, this parameter specifies if
outbound multicast frames with unknown destination addresses are
flooded toward wireless end devices
Multicast Outbound If multicast flood mode is not disabled, this parameter specifies if
to Secondary LANs outbound multicast frames with unknown destination addresses are
flooded toward secondary LANs.
Enabled The root access point controls flooding for all access points
serving as designated bridges for the secondary LANs.
Set locally Designated bridges for the secondary LANs control
flooding on their LANs.
Unicast Flood Mode Determines the flooding structure for inbound unicast frames with
unknown destination addresses.
Universal Allows any wireless end device to communicate with any
other wireless end device.
Hierarchical Allows wireless end devices to communicate with nodes
on the primary LAN but not with other wireless end devices.
Disabled Prevents flooding.
Unicast Outbound to If the unicast flood mode is not disabled, this parameter specifies if
Terminals outbound unicast frames with unknown destination addresses are
flooded toward wireless end devices. This parameter only applies to
802.11b and OpenAir radios.
Unicast Outbound to If the unicast flood mode is not disabled, this parameter specifies if
Secondary LANs outbound unicast frames with unknown destination addresses are
flooded toward secondary LAN segments.
Enabled The root access point controls flooding for all access points
serving as designated bridges for the secondary LANs.
Set locally Designated bridges for the secondary LANs control
flooding on their LANs.
Configuring the Spanning Tree
4
4-11