Intermec MobileLAN 21 Series System Manual page 33

Note: You need to install the MobileLAN access Utility on a PC that is on the same IP
subnet as the access point.
Or, you need to install it on a PC with a wireless link (configured to Intermec's default
radio settings) to the access point. Before you use the utility, you must have an active
radio connection.
To use the MobileLAN access Utility
1. Insert the MobileLAN access Utility CD into your PC's CD-ROM drive. The CD
starts automatically and you will see the CD home page with menu buttons. Click
Install Software. If you do not see this home page, from the Start menu, choose
Run. In the Open field, type X :\INDEX.HTM, where X is the CD-ROM drive.
Or, use a Web browser to navigate to mobilelan.intermec.com. Click Software
Downloads and download the MobileLAN access Utility.
2. Follow the instructions that appear on your screen to install the utility.
3. Start the utility.
4. Click the down arrow on the right side of the Select Task field and choose Set IP
Address.
5. In the New IP Address field, enter the IP address.
6. In the Ethernet MAC Address field, enter the MAC address of the access point. This
address is located on the bottom of the access point.
7. Connect the power cable to the access point and to a power source. The access point
has no On/Off switch, so it boots as soon as you apply power.
1
Getting Started
1-17