Intermec MobileLAN 21 Series System Manual page 228

MobileLAN access 21XX System Manual
sdvars set terminate
Purpose: Sets the internal variable terminate to a specified value. Use terminate to stop a
countdown process in the access point. If either starttime or nextpoweruptime is
counting down, setting this variable stops the timer and halts the countdown process.
Note: You should use caution when using this command. If the script file is being
downloaded or executed, setting this variable interrupts the processing and can leave
the access point in an undetermined state that may require user intervention.
Syntax:
sdvars set terminate
sdvars set setactivepointers
Purpose: Sets the setactivepointers command to change inactive segments to active segments the
next time the access point is rebooted. This command is usually used with the
nextpoweruptime command.
Syntax:
sdvars set setactivepointers none/boot/data/both
where:
none
boot
data
both
Example: To change the inactive boot and data segments to active at the next reboot, enter:
sdvars set setactivepointers both
sdvars set nextpoweruptime
Purpose: Sets the nextpoweruptime command to set the internal variable nextpoweruptime to a
countdown time so that when 0 is reached, the access point will reboot. When the
nextpoweruptime counter reaches 0, the access point checks the value of the
setactivepointers variable, takes the appropriate action, and then reboots.
Note: If you need to terminate the reboot, you can do so by setting nextpoweruptime to
0 if it has not already been reached by the countdown. By resetting nextpoweruptime to
0, the timer is stopped so the unit does not reboot.
8-20
does not change the active segments. The default is
the reboot is completed, the access point resets this value to
changes the inactive boot segment to the active boot segment.
changes the inactive data segment to the active data segment.
changes both the boot and data inactive segments to the active
segments.
Also, when
none.
.
none