Intermec MobileLAN 21 Series System Manual page 69

3. Click the down arrow on the right side of the DHCP Mode field and choose "This
AP is a DHCP Server."
4. Click Submit Changes to save your changes.
5. Click DHCP Server Setup. The DHCP Server Setup screen appears.
6. Configure the DHCP server. For help, see the next table.
7. Click Submit Changes to save your changes and then click "here." To activate your
changes, from the menu bar click Save/Discard Changes and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes" in Chapter 1.
The following table explains each parameter.
Parameter Explanation
Low Address The low IP address in the range of IP addresses available to the DHCP
server for distribution to DHCP clients. If these addresses are not on the
same subnet as the access point, the access point will perform Network
Address Translation (NAT) for the devices to which it grants IP
addresses.
High Address The high IP address in the range of IP addresses available to the DHCP
server for distribution to DHCP clients. If these addresses are not on the
same subnet as the access point, the access point will perform Network
Address Translation (NAT) for the devices to which it grants IP
addresses.
DNS Address 1 The IP address of a Domain Name Server that will be distributed to
DHCP clients. You can enter up to two DNS addresses to be delivered
to DHCP clients.
Configuring the Ethernet Network
3
3-7