Intermec MobileLAN 21 Series System Manual page 224

MobileLAN access 21XX System Manual
TFTP PUT
Purpose: Copies a file from a TFTP client to the TFTP server or to another access point.
Syntax:
TFTP PUT IPaddress foreignfilename localfilename
where:
IPaddress
foreignfilename
localfilename
Example: The following command takes file UAP.PRG that is saved in the active boot drive on
the access point client and stores it in the inactive boot segment on the access point
server that has IP address 1.2.3.4.
TFTP PUT 1.2.3.4 IB:UAP.PRG AB:UAP.PRG
These error messages may be generated by the access point when the access point
issues a TFTP PUT command. Other error messages may be returned from the server
and displayed by the access point. See your server documentation for additional
information.
Error Message
Can't read file
Invalid opcode during put
TFTP SERVER LOG
Purpose: The access point can function as a TFTP server. You can use the TFTP server log
command to save a history of TFTP client requests. The TFTP server log contains
useful TFTP server status information. The log begins when you set up the server. To
clear the log, reboot the access point.
Syntax:
TFTP SERVER LOG
8-16
is the IP address of the server. You can use an asterisk (*)
here if you want to use the value in the serveripaddress.
is the name of the file as it will appear on the server. The file
name can contain directory path information and must be in
the format required by the server operating system.
is the name of the file to be sent from the access point.
Explanation
The requested file may not exist.
This error should not occur under normal operating conditions.
This error indicates a TFTP protocol error that will not occur
when you use TFTP servers that conform to the protocol.