Intermec MobileLAN 21 Series System Manual page 66

MobileLAN access 21XX System Manual
6. If you want to configure the access point as a DHCP server, see "Configuring the
7. Click Submit Changes to save your changes. To activate your changes, from the
The following table explains each TCP/IP parameter. The other parameters on this
screen are explained in the next sections.
Parameter
IP Address
IP Subnet Mask
IP Router (Gateway)
IP Frame Type
3-4
21XX as a DHCP Server" later in this section.
menu bar click Save/Discard Changes and then click Save Changes and Reboot. For
help, see "Saving Configuration Changes" in Chapter 1.
Explanation
Enter the IP address of the access point. The IP address has the form
x.x.x.x, where x is a number from 0 to 225.
Enter the subnet mask that matches the other devices in your network.
The subnet mask has the form x.x.x.x, where x is a number from 0 to
225.
Enter the IP address of the router that will forward packets if the access
point will communicate with devices on another subnet. The IP address
has the form x.x.x.x, where x is a number from 0 to 225.
This parameter controls the encapsulation of IP frames sent by this
access point. You select either DIX (Ethernet 2.0) or SNAP
encapsulation.
DIX Encapsulate using DIX (Ethernet 2.0) frames.
SNAP Encapsulate using SNAP frames. You need to use SNAP if
other network computers use SNAP encapsulation for IP frames.