Intermec MobileLAN 21 Series System Manual page 206

MobileLAN access 21XX System Manual
3. Configure the following parameters:
4. Click Start. When the Start Time expires, the upgrade starts. When the Next Power
5. From the menu, click Maintenance and then click About this Access Point to verify
To upgrade the access point using a TFTP server on your PC and a Telnet session
1. Start the TFTP server on your PC.
2. From an MS-DOS prompt, type
3. Choose Maintenance and then choose Command Console. This screen appears.
7-34
Parameter
Server IP Address
Script File Name
Start Time
Next Power Up Time
Up Time expires, the access point reboots and runs the new software.
If the upgrade is unsuccessful, the TFTP server prints an error message. When you
have corrected the problem, repeat Steps 2 through 4.
the new firmware versions.
address of the access point you want to upgrade. The Access Point Configuration
menu appears.
Description
Enter the IP address of your TFTP server. The TFTP
server has the upgrade file on it (usually your PC).
Enter the pathname and filename of the upgrade file
(UPNOPATH.DNL) on the TFTP server.
Specify the time the upgrade starts.
Specify when you want the access point to reboot. When
it is done rebooting, it will be running the new software.
Telnet IPaddress
, where IPaddress is the IP