If the default configurations will be used, you should exit the menu by typing the A
command. If you want to change any of the configuration functions, refer to the appro-
priate configuring the built-in interfaces sections later in this appendix.
There are three columns of information:
•
• Interface - the built-in configurable interfaces. If an interface listed in your
•
C.4.2
Example Interface Menu
You may select one or more keyboard configurable interfaces in any order. For each
interface, you can go to its Interface menu. The RS-232 Interface menu is shown in the
following example. To select the RS-232 Interface, type the command key for the
RS-232 interface:
[key] < Return >
The Configurable Interfaces menu gets replaced with this RS-232 menu:
RS-232
Key Feature
---------------------------
1 Select Code
2 Interrupt Level
3 Remote/Local
4 Modem Enable
X to exit menu
---------------------------
Type [key] RETURN ?
Keys - the keyboard number keys represent the interface you want to select to
configure. Letter keys are for control functions.
screen's left-hand side does not appear in the Main Configuration menu, that
interface cannot be configured from I/O Configure Mode.
Select Code - the listed interfaces select code. The standard-speed HP-IB in-
terface is fixed at select code 7. When you get the power-up display in HP-
UX compatible mode or enter I/O Configuration Mode, default select codes
are listed. If you change an interface select code and save the new configura-
tion, the new select code is listed the next time you turn on your system unit.
You may also revert back to the default settings.
Value
9
5
L
Y
Configuring the EEPROM
C-15