Removing The Eeprom (Model 400T And 400Dl - HP 400 Series Servicing Manual

8. Use the EEPROM puller (AMP part no. 821903-1) to remove the EEPROM from
Figure 5-13. Removing the EEPROM (Model 400t and 400dl)
9. Install the new CPU board. Make sure that you align the board's external con-
10. Install the cables, boards, and memory modules that you removed earlier.
11. Replace the top cover.
12. Connect the power cord to the system unit and then to the wall outlet.
13. Power on the system.
5-16 FRU Removal and Replacement
the defective CPU board and from the new CPU board (see Figure 5-13). Insert
the EEPROM from the defective CPU board into the new CPU board, and insert
the new EEPROM into the defective CPU board. When you insert the EEPROMs
make sure that you orient the flat corner of the EEPROM to the flat corner of the
socket, and that the writing on the EEPROM faces up.
nectors with the slots in die rear of the system unit.