Dio-Ii Center Wall Removal And Replacement - HP 400 Series Servicing Manual

5.5.28 DIO-II Center Wall Removal and Replacement (Model 400s)
Refer to Figure 5-46 and follow these steps to remove the DIO-II center wall:
1. Remove the top and side covers, CPU board with plate attached, all DIO cards
2. Remove the LED cable clamp from the chassis.
3. Remove the screw at the back, right-hand corner of the center wall.
4. Remove the two screws on the right, front edge of the center wall.
5. Remove the three screws on the left, bottom edge of the chassis to the center
6. Remove the three screws on the left, top edge of the chassis to the center wall.
7. Remove the center wall towards the right side.
To replace the DIO-II center wall, follow these steps:
1. Ensure that the main power distribution and main fan cables are wedged under
2. Place the center wall on the chassis ensuring that the motherboard's tabs fit into
3. Start one screw in a left, top, center hole in the chassis to the DIO-II center wall.
4. Start another screw in the oval hole in the back of the chassis just below the right
5. Install the remaining screws for the center wall.
6. Verify all cables are not pinched and that the center wall fits correctly.
7. Tighten all of the screws.
8. Replace the LED cable clamp and the other assemblies.
5-66 FRU Removal and Replacement
and the 3-slot DIO-II card cage.
wall.
the chassis' cable tab above the front main fan. Ensure that the cables are not
pinched anywhere.
their slots on the center wall. The back lower edge must fit inside the chassis.
A tab at the chassis' upper, rear corner should fit into a hole on the center wall
to hold the center wall in place while you install the screw. Do not completely
tighten the screw.
edge of the center wall. Do not completely tighten the screw.