Configure/View Interface Settings Menu - HP Kayak XU 04xx Administration Manual

Configure/View
Interface Settings Menu
Configuring the SCSI Bus
Use the and
the SCSISelect utility. Press
menu.
It is recommended that you do not change these settings.
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID . . . . . . . . . . . . . . 7
SCSI Parity Checking . . . . . . . . . . . . . . Enabled
Additional Options
Boot Device Options
SCSI Device Configuration
Advanced Configuration Options . . . . . . . . . Press <Enter>
<F6> - Reset to Host Adapter Defaults
BIOS Information
Interrupt (IRQ) Channel . . . . . . . . . . . . . . 15
I/O Port Address
SCSI Channel Interface Definitions:
• Host Adapter SCSI ID
Changes the adapter SCSI ID from its default value of 7.
• SCSI Parity Checking
Enable or disable host adapter SCSI parity checking. Most currently
available SCSI devices do support SCSI parity. You should disable
SCSI Parity Checking if any of the attached SCSI devices do not
support SCSI parity.
Additional Options:
• Boot Device Options
Press
described on the next page.
• SCSI Device Configuration
Press
2 English
keys and the
at any time to return to the previous
SCSISelect(TM) Utility v1.xxx
. . . . . . . . . . . . . . Press <Enter>
. . . . . . . . . . . Press <Enter>
. . . . . . . . . . . . . . . . . F800h
to display the Boot Device Configuration menu,
to display the SCSI Device Configuration menu.
key to make selections in