HP 400 Series Servicing Manual page 145

3. From the Auto System Select Mode, note the tape drive with the System Support
Tape with these operating systems:
SYSTEM_SF
SYSTEM_S3
4. If you want to run the Series 300 System Functional Tests, select SYSTEM_SF
as the temporary operating system to boot.
If you want to run the Series 300 Computer Tests select SYSTEM_S3 as the tem-
porary operating system to boot.
Refer to the System Support Tape User's Guide and the Series 300 Test Tools
Manual for detailed instructions.
5. To continue and run specific ce.utilities tests, boot the HP-UX operating system.
The remaining steps of this procedure can only be performed with the HP-UX
operating system running.
6. To list all tests on the tape, type the following command where drive is the de-
vice file name of the tape drive:
lifls /dev/drive < Return >
7. To find out what files are available for a certain test, type the following com-
mand:
lifcp -r /dev/drive: filename1 - | cpio -ictv < Return >
where filename1 is one of these six ce.utility tests:
CRTADJ FLOAT
CS80 SFT
Note that the HP 98720A and HP 98730A tests are not supported on Series 400
system units.
8. If you want to list the file names for a specific ce.utility test in a new file, type the
following command where filename2 is the name of the file in which you want
to list the files:
lifcp -r /dev/drive: filename1 - | cpio -ictv [ > filename2 ] < Return >
9. To read the list of file names, type the following command:
more filename2 < Return >
ECC
VME
Fault Isolation 4-75