C-1 Configuring Internal Interfaces - HP 400 Series Servicing Manual

NOTICE:
The following procedure explains how to configure internal interfaces.
Procedure C-1 Configuring Internal Interfaces
To configure internal interfaces, perform the following steps:
1. If you have already booted an operating system, log out and stop any user pro-
2. Reset the system unit and get the power-up display, then when the keyboard is
3. From the Configuration Control menu, type this command to get the I/O Con-
4. From the I/O Configuration menu, type the number command for the interface
5. Type the number command for the feature you want to change:
6. Type the number or letter key(s) command to change the feature:
7. Exit the selected interface menu by typing X < Return >
8. Type the letter key command to store the new or default values, or abort and
C-24 Configuring the EEPROM
After you have made the required changes to your system
unit's built-in interface configurations, you must use the In-
terface menu and make the changes permanent. Otherwise, if
you turn the system unit off, then back on again, the original
interface configurations will be in effect.
cesses. Otherwise, go on to step 2.
identified, type the command
C < Return >
figuration menu:
1 < Return >
you want to configure:
key < Return >
key < Return >
key(s) < Return >
not make any changes:
key < Return >