Model 400S Internal Scsi Cable Removal - HP 400 Series Servicing Manual

Figure 5-30. Model 400s Internal SCSI Cable Removal
Follow these steps to replace the internal SCSI cable:
1. Position the SCSI cable in the unit with the terminator end at the top. Then,
replace the screw to hold the terminator in place.
2. Fit the SCSI cable to the top cable clip with the two top connectors above the
top cable clip.
3. Fit the SCSI cable to the bottom cable clip with one cable connector between
the top and bottom cable clip.
4. Connect the SCSI cable's end connector to the motherboard SCSI cable con-
nector.
5. Connect the SCSI cable connector to the mass storage devices.
6. Replace the mass storage devices and all other assemblies that you removed
earlier.
FRU Removal and Replacement 5-39