HP 400 Series Servicing Manual page 263

Type E < Return > to execute the menu selections.
Type C < Return > to clear any temporary selection.
After executing the Boot Mode Selection menu with HP-UX compatible mode select-
ed, the system unit resets and the following power-up display appears:
Copyright 1990,
Hewlett-Packard Company,
All Rights Reserved.
Series 400, Rev. 1, 5 Jun 90
md 12 rev 0.20, 1990/03/12.16:31:17
Bit-Mapped Video
MC680n0 Processor
.
.
.
System Search Mode
RESET to Power-up SPACE clears input
As soon as you see this display for HP-UX compatible mode, you have these options:
• Do nothing and the Boot ROM searches for an HP-UX compatible operating
system. If one is found, it boots it. For system units that have pre-installed
operating systems, this is the correct procedure.
• Type any key to stop the Boot ROM functions and place the system unit in an
attended mode.
While in attended mode, you may do one of the following as soon as the keyboard line
appears in the power-up display:
• Type any key to stop the Boot ROM process and put the system unit in at-
tended mode. From attended mode, you may also do the next two options.
• Type C < Return > to enter Configuration Control Mode to change the Boot
Mode Selection, Auto System Select, or I/O Configuration.
• Type T < Return > to enter lest Mode and run the Boot ROM diagnostics.
If you are turning on a new system unit for the first time and need to change the inter-
nal interface configurations or change the Auto System Select Mode, you should type
the command C < Return > to enter Configuration Control Mode. Then you may
Configuring the EEPROM
?
C-11