Mass Storage Power Distribution Cable Removal And Replacement - HP 400 Series Servicing Manual

5.5.12

Mass Storage Power Distribution Cable Removal and Replacement

(Model 400s)
Refer to Figure 5-31 and follow these steps to remove the mass storage power distribu-
tion cable:
1. Remove the top and side covers, right trim plate, and mass storage covers.
2. Disconnect the mass storage power distribution cable from the back of the
3. Remove the power cable from the cable clips at the back of the mass storage
Figure 5-31. Model 400s Mass Storage Power Distribution Cable Removal
5-40 FRU Removal and Replacement
Slide out all internal mass storage devices about two inches.
motherboard and all mass storage devices.
device cage. Then, remove the cable from the unit.