Removing and Replacing Mass Storage Devices
Removing Mass Storage Module
CAUTION:
NOTE:
Procedure
1
Disconnect any SCSI cables connected to module.
2
Unscrew both Mass Storage Module screws.
3
Slide out tray. See Figure 5-6.
4
If replacing a device go to Selecting Device Address.
5
If the only action is to remove a device go to Mass Storage Device Removal.
Figure 5-6
5-16
The mass storage module can weigh about 10 lbs, and may be
awkwardly balanced. Use care when handling the module, as
dropping it could damage the mass storage devices!
All Installation procedures are the reverse of removal in this
section.
Mass Storage Tray Removal