Marking Trigger Input: Single Trigger - Panasonic LP-GS Series Setup & Maintenance Manual

4-6-3 Marking trigger input: Single trigger

When the trigger mode is set to "single trigger" in the file settings, one lasing operation is executed by the edge of turning
on of TRIGGER IN (X5).
ON
READY OUT (Y5)
OFF
ON
TRIGGER IN (X5)
OFF
ON
PROCESSING OUT
(Y10)
OFF
ON
LASING OUT (Y20)
OFF
ON
PROCESSING END
OUT (Y11)
OFF
ON
PROCESSING FAIL
OUT (Y12)
OFF
ON (Normal)
WARNING OUT (Y14)
OFF (Error)
ON (Normal)
ALARM OUT (Y15)
OFF (Error)
Item Time
T1 2ms or more
T2 ―
T3 0 to 9999ms
T4 2 to 510ms
T5 Approx. 3 sec.
T6 2 to 510ms
T1
T2
T3
T4
Remarks
Keep the ON status for 2ms or more.
When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON. The output time
of PROCESSING OUT (Y10) includes the trigger delay time, marking preparation time,
laser radiation time, and processing time after marking has completed.
If you are not using the link function with external devices, output time of PROCESSING
OUT (Y10) is almost the same as the total duration of the trigger delay time and LASING
OUT (Y20).
When the trigger delay time is set in the selected file, trigger processing (lasing) operation
starts after the delay time.
This is the output to notify that the marking trigger processing completed normally. This
is One-shot output. Set the output time on the system settings screen. There is a small
margin of error for the setting value.
It outputs a warning to notify that an invalid trigger was input when TRIGGER IN (X5) was
input during trigger processing. This is One-shot output. You can turn this warning off by
the settings.
If the trigger processing was stopped by an alarm or a warning, PROCESSING FAIL OUT
(Y12) turns on during the one-shot output period. PROCESSING END OUT (Y11) will not
be output at this time.
ME-LPGS-SM-8
T1
T2
T3
T4
T5
T1
Marking
interruption
Marking
interruption
T3
T6
95