Lasing Trigger Input: Single Trigger - Panasonic VL-W1 Series Setup And Maintenance Manual

4-6-3 Lasing trigger input: Single trigger

When the trigger mode is set to "single trigger" in the file option screen, one lasing operation is executed by the edge of
turning on of TRIGGER IN (X6).
READY OUT (Y6)
TRIGGER IN (X6)
LASING OUT (Y7)
LASING END OUT (Y8)
WARNING OUT (Y12)
ALARM OUT (Y13)
Item Time
T1 10 ms or more
T2 0 to 5000 ms
T3 20 to 510 ms
T4 20 to 510 ms
114
ON
OFF
ON
T1
OFF
ON
T2
OFF
ON
T3
OFF
ON (Normal)
OFF (Error)
ON (Normal)
OFF (Error)
Remarks
Keep the ON status for 10 ms or more.
When the trigger delay time is set in the selected file, lasing operation starts after the delay
time.
This is the output to notify that the lasing operation ended. Even when the lasing operation
is interrupted due to the alarm or warning occurrence, LASING END OUT (Y8) turns ON.
This is One-shot output. Set the output time on the environment setting screen. There is a
small margin of error for the setting value.
READY OUT (Y6) is not turned ON while LASING END OUT (Y8) is ON.
It outputs a warning to notify that an invalid trigger was input when TRIGGER IN (X6) was
input during the lasing operation. This is One-shot output. You can turn this warning off by
the settings.
T1
T2
T4
ME-VLW1-SM-8
T1
T2
T3 T3
Interrupt
lasing