Signals And Details Of I/O Terminal Block - Panasonic LP-GS Series Setup & Maintenance Manual

4-2 Signals and Details of I/O Terminal Block

The I/O terminal block is loaded with the basic input/output to control the laser marker.
„ List of signals
No. Name
X1 24V OUT
Internal power 24V
X2 IN COM. 1
Input common 1
X3 0V OUT
Internal power 0V
X4 REMOTE IN
X5 TRIGGER IN
X6 LASER SUPPLY IN
X7 RESERVE
System reservation
X8 SHUTTER IN
X9 SHUTTER ENABLE IN
X10 LASER STOP 1 IN
X11 LASER STOP 2 IN / LASER STOP 1 IN
X12 OUT COM. 1
Output common 1
X13 RESERVE
System reservation
X14 RESERVE
System reservation
X15 ALARM RESET IN
X16 INTERLOCK 1(+)
X17 INTERLOCK 1(-)
X18 INTERLOCK 2(+)
X19 INTERLOCK 2(-)
X20 N.C.
Not connected
• Use the internal power (X1, X3, Y1, Y3) as the power supply when operating the laser marker alone. Do not connect
anything when using the external power supply.
• Do not connect anything to RESERVE terminals and N.C. terminals.
• Some terminals are already connected by the short bars with shipment. Refer to "4-5-1 Factory default wiring" (P.88).
• For details on the terminal block connection, refer to "4-5 Connecting I/O Terminal Block" (P.88).
70
No. Name
Y1 0V OUT
Internal power 0V
Y2 OUT COM. 1
Output common 1
Y3 24V OUT
Internal power 24V
Y4 REMOTE OUT
Y5 READY OUT
Y6 LASER STANDBY OUT
Y7 SYSTEM STANDBY OUT
Y8 SHUTTER OPEN 1 OUT
Y9 SHUTTER OPEN 2 OUT
Y10 PROCESSING OUT
Y11 PROCESSING END OUT
Y12 PROCESSING FAIL OUT
Y13 RESERVE
System reservation
Y14 WARNING OUT
Y15 ALARM OUT
Y16 INTERLOCK 1 MONITOR
Y17 INTERLOCK 1 MONITOR COM.
Y18 INTERLOCK 2 MONITOR
Y19 INTERLOCK 2 MONITOR COM.
Y20 LASING OUT
ME-LPGS-SM-8