Controller Installation - Panasonic LP-GS Series Setup & Maintenance Manual

2-4 Controller Installation

WARNING
„ Carrying the controller
To carry the controller, hold the bottom of the unit with both hands.
Do not hold the cables or connectors at carrying this product.
„ Installation method
• The controller may be installed vertically or horizontally.
• For horizontal installation, ensure that the key switch side is at the bottom.
• For details of installation, refer to "1-5-2 Controller" (P.25).
• Fix the controller in the following conditions.
Fixing surface
Bottom
Side (front left side)
• Do not insert any screw of length exceeding the specification. Otherwise, the failure of the product may be caused.
• Do not install the laser marker at a place where vibrations and shocks can be directly transmitted to it. In any
environment where effects of vibration are concerned, take measures against vibration on the product, e.g. fitting rubber
feet.
40
• Make sure that the power is turned OFF at installing. Failure to do so may
cause electrical shock.
• To carry this product, wear the non-slip gloves.
• In case it falls down, it may cause injury.
Fixing screw
M5 screws at 4 positions
M5 screw
ME-LPGS-SM-8
Screw insert length
6 mm or below
Tightening torque
2.0 N·m or below
M5 screw