Panasonic LP-GS Series Setup & Maintenance Manual page 133

„ Position correction - Marking - Image checking (when TIMING IN signal is not used)
TRIGGER IN (X5)
READY OUT (Y5)
CHECK OK OUT (No.34)
or
CHECK NG OUT (No.35)
PROCESSING OUT (Y10)
LASING OUT (Y20)
SCRIPTING OUT (No.37)
PROCESSING END OUT (Y11)
*1: CHECK OK OUT (No.34) / CHECK NG OUT (No.35) outputs before PROCESSING OUT (Y10) is turned OFF.
Item Time
T1 2ms or more
T2 ―
T3 ―
T4 ―
T5 ―
T6 2 to 510 ms
ON
T1
OFF
Starting a series of interfaced operations signal
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
T3
OFF
ON
OFF
Remarks
Keep the ON status for 2ms or more.
When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON.
The output time of PROCESSING OUT includes the trigger delay time, operation time,
laser radiation time and laser marker internal processing time of the linkage devices.
Processing time of linkage operations with the image checker.
In this case, it is the following time.
• Time for location detection by image checker
• Time for marking position correction by the laser marker
Laser radiation time. The time varies depending on marking contents.
Processing time of linkage operations with the image checker.
In this case, it is the following time.
• Time for reading by the image checker
• Time for transferring the checkup results from the image checker to the laser marker
One-shot output. Set the output time on the system settings screen.
There is a small margin of error for the setting value.
ME-LPGS-SM-8
*1
T2
T4
T5
T6
T6
133