Marking Trigger Input; Equidistant Marking (Flying Object Marking) - Panasonic LP-M Series Maintenance Manual

3-5-2 Marking trigger input

READY OUT
TRIG. IN
MARKING OUT
WARNING OUT
(Active Low)
Item Period
T1 10 ms or more
T2 2 to 510 ms
• The marking is started when TRIG. IN is turned to ON while either the delay time or delay distance is 0.
• LP-Mxxx-S type requires the laser gate open / close control for trigger marking. Refer to "Marking operation timing chart
during remote and operating modes" (P.122) for detail.

3-5-3 Equidistant marking (flying object marking)

READY OUT
TRIG. IN
MARKING OUT
MARK END OUT
Item Time
T1 ―
T2 ―
T3 2 to 510 ms
• Equidistant marking is performed while TRIG. IN is ON.
• The laser marker stops after marking is completed if TRIG. IN is turned to OFF during marking.
• Equidistant marking is performed after travels the distance that is set in the "trigger ready".
100
ON
OFF
ON
T1
OFF
ON
OFF
ON
OFF
Remarks
Keep the ON status for 10 ms or more.
It outputs a warning to notify that an invalid trigger was input when a marking trigger was
input during trigger processing. This is One-shot output. You can turn this warning off by
the settings.
ON
OFF
ON
OFF
T2
ON
T1
OFF
ON
T3
OFF
Remarks
The time when the work travels the distance set in the "trigger ready."
The time when the work travels the distance set by marking interval.
One-shot output. Set the output time on the environment setting screen.
There is a small margin of error for the setting value.
T1
T2
T2 T2
T3 T3
ME-LPM-SSM-10
T3