Panasonic LP-GS Series Setup & Maintenance Manual page 66

12.
On the "Command format" panel, specify the communication command format.
• Start code: STX (initial setting) / None
• Include command in response: ON (initial setting) / OFF
• Sub-command for response data: Any single byte character
of ASCII code from 01(HEX) to 7F(HEX) can be specified.
• Initial setting of positive response code: A
• Initial setting of negative response code: E
• Initial setting of read request response code: A
• Encoding for 2-byte characters: Shift-JIS (initial setting) / GB
2312
• For details of the command format, refer to the "Serial
Communication Command Guide".
• The command format settings here are applied to the standard
communication format and not applied to LP-400/LP-V compatible format. For the details of the compatible mode with
the former models of LP-400/LP-V series, refer to the "Serial Communication Command Guide: LP-400/V compatible
mode".
• "Encoding for 2-byte characters" is used for the Japanese and Chinese characters which cannot be specified by the
ASCII codes. To use Japanese, set "Shift-JIS" and for simplified Chinese, set "GB 2312".
13.
To input the control codes in the barcode/2D code strings using the communication commands,
click "Details" of "Input method for control codes" and select the input method.
14.
Click "Set" on the lower right corner of the screen.
15.
Disconnect the online connection with the laser marker.
16.
Turn OFF the laser marker power and wait for five seconds or more, then restart.
The configured items will be reflected to the laser marker.
• Do not turn the laser marker power OFF while being connected to online.
17.
The control by the external device starts by switching the laser marker to the remote mode.
• For the details of the System settings, refer to "Laser Marker NAVI smart Operation Manual".
66
ME-LPGS-SM-8