Modifying An Interface - 3Com SUPERSTACK 2200 User Manual

3-6 C 3: C
HAPTER ONFIGURING
Top-Level Menu
system
ethernet
interface
fddi
route display
bridge
arp define
ip
rip
modify
snmp
ping
remove
analyzer
statistics
script
logout
M A
ANAGEMENT CCESS TO THE
3 Enter the subnet mask of the network to which the interface is to be
connected.
4 Enter the broadcast address to be used on the interface.
5 Enter the cost value of the interface.
6 Enter the port(s) that you want to include in the interface. Separate
nonconsecutive ports with commas (,). Enter a consecutive series of ports
using a hyphen (-).
Example:
Enter IP address:
Enter subnet mask [255.255.0.0]:
Enter broadcast address [158.101.1.255]:
Enter cost [1]:
Ports 1-2=FDDI, 3-18=Ethernet
Select port(s) (1-18|all):
If you physically change the configuration of your system after defining IP
interfaces, the ports designated for those interfaces might no longer be valid.
You should reconfigure your interfaces.

Modifying an Interface

To modify an IP interface that you have already defined:
1 From the top level of the Administration Console, enter:
ip interface modify
You are prompted for the interface parameters. Press [Return] at the
prompts for which you do not want to modify the value in parentheses.
2 Modify the existing interface parameters by entering a new value at the
prompt.
S
YSTEM
158.101.1.1
255.255.255.0
2-4,8