3Com SUPERSTACK 2200 User Manual page 17

1-2 C 1: S
HAPTER UPER
Table 1-1 General System Commands
Task
Run a script of commands to set up a system
Write a script of Console commands with the values you assign
so that you can quickly configure one or more systems. You can
run the same script on a number of systems to ensure
consistent setup.
Display the system configuration
Display software and hardware revisions and certain warning
messages.
Install software into flash memory
Update your system software. Software is initially installed at
the factory.
Display, set, enable, or disable a baseline for statistics
Establish and use baselines for Ethernet, FDDI, and bridging
statistics to evaluate recent activity in your system and on your
network.
Configure timeout for remote sessions
Configure the system to disconnect remote sessions after a
specified time interval.
Control access to the Console
Set passwords for levels of access (read, write, administer) and
prohibit remote access during your session by locking the
Console.
Name the system
Assign the system a unique name for management purposes.
For example, you might name a system based on its location:
Switch2200-Floor2.
Set the system date and time
Ensure that messages are accurately logged. The internal clock
is set at the factory; change it for your time zone.
Set screen height
Adjust the console screen height for your terminal.
Enable the [Control] keys when working in the Console
Enable quick keys for the reboot (Ctrl+X) and abort (Ctrl+C)
functions.
(continued)
S ™ II S 2200 A
TACK WITCH
O
DMINISTRATION VERVIEW
Quick Command
script
system display
system softwareUpdate
system baseline
system telnet
system password
system consoleLock
system name
system time
system screenHeight
system ctlKeys
For Details, See. . .
page 2-13
page 4-1
SuperStack™ II Switch
2200 Software Installation
and Release Notes
page 5-2
page 2-12
page 4-2
page 3-20
page 4-3
page 4-3
page 2-10
page 2-11