3Com SUPERSTACK 2200 User Manual page 19

1-4 C 1: S
HAPTER UPER
Table 1-2 System Management Setup Commands (continued)
Task
Configure SNMP management
Display current SNMP configurations and specify the type of
authorization for SNMP management.
Configure SNMP trap reporting
Display SNMP trap reporting information, add or modify trap
reporting destination configurations, remove trap destinations,
flush all SNMP trap reporting destinations, and set up SMT
event proxying.
Table 1-3 Bridging Commands
Task
Display bridge information
Display information about the bridge, such as statistics, bridge
configurations, and spanning tree configurations.
Enable or disable IP fragmentation
Enable or disable the fragmenting of large FDDI packets to
allow FDDI and Ethernet stations to communicate using IP.
Enable or disable IPX snap translation
Enable or disable the translation of 802.3_RAW IPX packets to
FDDI_SNAP packets (when going from Ethernet to FDDI), and
vice versa (when going from FDDI to Ethernet). The default is
disabled.
Set the bridge address threshold
Specify the reporting threshold for the total number of Ethernet
addresses known to the bridge. The SNMP trap
addressThresholdEvent is generated when the threshold is
reached.
Set the bridge address aging timer
Specify how often dynamically learned addresses are aged by
the bridge port. Appropriately configured aging prevents
packet flooding.
(continued)
S ™ II S 2200 A
TACK WITCH
O
DMINISTRATION VERVIEW
Quick Command
snmp display
snmp community
snmp trap display
snmp trap addModify
snmp trap remove
snmp trap flush
snmp trap smtProxyTraps
Quick Command
bridge display
bridge ipFragmentation
bridge ipxSnapTranslation
bridge addressThreshold
bridge agingTime
For Details, See. . .
page 3-15
page 3-16
For Details, See. . .
page 10-1
page 10-5
page 10-5
page 10-6
page 10-6