Blocks - CEA DIGITECH vision PULSE Series Operator's Manual

BLOCKS

The purpose of this menu is to allow the operator to block or limit use of the welding machine and/or certain welding parame-
ters / functions.
To access the BLOCKS Menu from the SETUP Menu:
• Turn the ENCODER K
NOB
• Push the ENTER/MEM K
EY
The image graphically shows how the type of block is shown on the VISION S
ENCODER K
Within the BLOCKS Menu it is possible to select, by rotating the ENCODER K
require confirmation) from the 4 options available:
Block type
NONE
BLOCK TYPE
LEVEL 1
BLOCK TYPE
LEVEL 2
BLOCK TYPE
USER BLOCK
BLOCK TYPE
CURR./WIRE SPEED CHANGE
ARC LENGTH/VOLTAGE CHANGE
INDUCTANCE CHANGE
PROCESS CHANGE
PROGRAM CHANGE
JOB CHANGE
MODE CHANGE
SPECIAL FUNCTION CHANGE
To exit the BLOCKS Menu and go back to the SETUP Menu:
• Push the MENU K
.
EY
- SX to select the desired icon.
.
MENU K
EY
SX K
EY
- SX
NOB
BLOCK ABSENT or RELEASE MACHINE
Does not allow any block to be activated on the welding machine, but allows the operator
to release the machine if its was blocked previously.
NONE
PARTIAL BLOCK
The operator can weld using the parameters set prior to the block and may make
adjustments and/or changes to the welding parameters using the knobs on the control
panels on the welding machine and the wire feeder (if fitted).
LEVEL 1
TOTAL BLOCK
The operator can weld only using the parameters set prior to the block and cannot adjust
and/or edit the welding parameters.
LEVEL 2
PERSONALISED BLOCK
Used to block or limit some adjustments and/or functions of the welding machine.
USER BLOCK
BLOCKED
BLOCKED
BLOCKED
DISABLED
DISABLED
DISABLED
DISABLED
DISABLED
when the welding machine is operating normally.
CREEN
A V
L2
212 24
PROGRAM 0011
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
- DX, the block required (this operation does not
NOB
Description
58
SETUP Menu
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN