Hold - CEA DIGITECH vision PULSE Series Operator's Manual

ENCODER K - A
NOB
PARAMETER DISPLAY S
CREEN
PARAMETER SELECTION LED - V
PARAMETER SELECTION K
EY
ENCODER K - V
NOB
SPECIAL FUNCTIONS (F ) K
X EY

5 - HOLD

When welding ends the fields in the display must show the same values that were displayed during welding, with the difference
that they are now values defined as HOLD. In this phase the VISION S
panel the HOLD F LED flashes until the end of the HOLD Function. If the HOLD Function is Interrupted via a panel (e.g. DH),
UNCTION
it will also be interrupted automatically on the other (HT4) and vice-versa.
ENCODER K
MENU K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
Adjust the value of the parameter WELDING CURRENT ( ).
In this case the values displayed become those pre-set.
After a period of 3 seconds the values displayed go back to those measured if possible.
Shows the value (measured, if possible) for the parameter indicated by the PARAMETER
- V
SELECTION LED - V.
The LED unit indicates the welding parameter selected using the PARAMETER SELECTION K
- V.
Scrolls in succession the parameters HOT START ( ) - WELDING VOLTAGE ( ) - ARC
- V
FORCE ( ) only on the HT4 panel.
Scrolls in succession the parameters HOT START ( ) - ARC FORCE (
Only enables entering and exit afterwards from the SPECIAL FUNCTIONS Menu (SET UP
Fx) on the HT4 panel and not on the DH panel.
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access the PROCESS SELECTION Menu (PROCESS) interrupting the HOLD
Function and subsequent menus, as applicable.
Adjusts the WELDING CURRENT ( ) parameter, interrupting the HOLD Function.
If held down for 3 consecutive seconds, it interrupts the HOLD Function and makes it
possible to access SAVE JOB.
Scrolls in succession WELDING VOLTAGE ( ) - HOT START ( ) - ARC FORCE ( ) only
on the VISION S
In this case the values displayed are those for HOLD (only for the welding voltage).
Adjusts the parameter selected using the DX K
shows the HOLD box highlighted, while on the HT4
CREEN
A V
68 7.2
PROGRAM 3200
MMA Cr Ni
(the operation is activated when the key is released).
CREEN
43
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
interrupting the HOLD Function.
EY
EY
).
MMA
VRD
ACTIVE