Blocks - CEA DIGITECH vision PULSE 3200 Operator's Manual

SET PASSWORD
077
STORE PASSWORD?
SET PASSWORD
000
STORE PASSWORD?
To exit the PASSWORD Menu and go back to the SETUP Menu:
• Push the MENU K .
EY

BLOCKS

The purpose of this menu is to allow the operator to block or limit use of the welding machine and/or certain welding parame-
ters / functions.
To access the BLOCKS Menu from the SETUP Menu:
• Turn the ENCODER K
NOB
• Push the ENTER/MEM K
EY
The image graphically shows how the type of block is shown on the VISION S
ENCODER K
Within the BLOCKS Menu it is possible to select, by rotating the ENCODER K
require confirmation) from the 4 options available:
Block type
NONE
BLOCK TYPE
EDITING THE EXISTING PASSWORD
WARNING: This operation is only possible after having accessed the SETUP Menu using the password
you wish to edit!
To edit the existing PASSWORD proceed as follows:
• Make sure the VISION S
between 001 and 999).
• Choose the new PASSWORD to be entered by rotating the ENCODER K
• Push the ENTER/MEM K
EY
• Push the SX K to confirm and finalise editing of the PASSWORD.
EY
• To cancel the operation of editing a PASSWORD push the DX K
DELETING THE EXISTING PASSWORD
WARNING: This operation is only possible after having accessed the SETUP Menu using the password
you wish to delete!
To delete the existing PASSWORD proceed as follows:
• Make sure the VISION S
between 001 and 999).
• Take the VISION S to number 000 by rotating the ENCODER K
CREEN
• Push the ENTER/MEM K
EY
• Push the SX K to confirm and finalise deleting of the PASSWORD.
EY
• To cancel the operation of deleting a PASSWORD push the DX K
- SX to select the desired icon.
.
MENU K
EY
- SX
NOB
BLOCK ABSENT or RELEASE MACHINE
Does not allow any block to be activated on the welding machine, but allows the operator
to release the machine if its was blocked previously.
NONE
shows the PASSWORD entered previously (a number that must be
CREEN
to confirm the operation of editing the PASSWORD.
shows the PASSWORD entered previously (a number that must be
CREEN
to confirm the deletion of the PASSWORD.
CREEN
A V
L2
212 24
PROGRAM 0011
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
NOB
40
- DX.
NOB
.
EY
- DX.
NOB
.
EY
when the welding machine is operating normally.
ENTER/MEM K
EY
ENCODER K
NOB
- DX, the block required (this operation does not
Description
SETUP Menu
- DX
(continued)