Welding Process Selection Menu (Process); Mig Pulse; Program Selection Menu (Program) - CEA DIGITECH vision PULSE Series Operator's Manual

WELDING PROCESS SELECTION Menu (PROCESS)

To access the PROCESS SELECTION Menu (PROCESS) push the MENU K
ENCODER K
MENU K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
It is not possible to access the PROCESS SELECTION Menu (PROCESS) via the HT4 control panel.

MIG pulse

1 - PROGRAM SELECTION Menu (PROGRAM)

To access the PROGRAM SELECTION Menu (PROGRAM) push the MENU K
ENCODER K
MENU K
EY
ENCODER K - SX
NOB
ENTER/MEM K
EY
It is not possible to access the PROGRAM SELECTION Menu (PROGRAM) via the HT4 control panel.
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Provides access to the next menus.
Select the welding process.
This key is used to access PRE-SETTING for the process selected.
"HT4" CONTROL PANEL
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access subsequent menus if there are any.
Select the welding program.
Used to access PRE-SETTING of the program selected.
"HT4" CONTROL PANEL
.
EY
MIG PULSE
MIG DUAL PULSE
MIG/MAG SYNERGIC
MIG/MAG MANUAL
MMA
TIG LIFT
2011 Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
.
EY
PRG MATERIAL Ø GAS
1011 Fe G3 SI-1 0.8 Ar 16-20% CO2
1012 Fe G3 SI-1 1.0 Ar 16-20% CO2
1013 Fe G3 SI-1 1.2 Ar 16-20% CO2
1014 Fe G3 SI-1 1.6 Ar 16-20% CO2
1021 Fe G3 SI-1 0.8 Ar 11-15% CO2
1/50
1011 Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
7
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
MIG pulse
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN