Pre-Setting - CEA DIGITECH vision PULSE Series Operator's Manual

Special function
FINAL CRATER TIME
BURN BACK
POST GAS
FIRST SLOPE ( I TO I )
1 2
CYCLE WIRE SPEED
CYCLE VOLTAGE
SECOND SLOPE ( I TO I )
2 1
ACS / ENCODER SPEED
WARNING:
• The STANDARD or ADVANCED welding CYCLE mode can only be activated by opening the ADVANCED SETUP Menu - AD-
VANCED MODE - CYCLE (for further explanations, see the relevant paragraph).
• It is possible to access editing of the SPECIAL FUNCTIONS (Fx) during welding.
• Some of the values edited will be used immediately by the operator, while others will be active from when the next welding
task begins.
• The HOLD function is not active within the SPECIAL FUNCTIONS Menu (SET UP Fx).

3 - PRE-SETTING

ENCODER K
MENU K
EY
ENCODER K - SX
NOB
DX K
EY
ENCODER K - DX
NOB
PARAMETER DISPLAY
Screen - A
F15
bub
PoG
F18
F19
F20
F21
F28
"DH" CONTROL PANEL
MENU K
EY
SX K
EY
- SX
NOB
Used to access the PROCESS SELECTION Menu (PROCESS) and subsequent menus, as
applicable.
Adjusts the parameter selected using the SX K
Scrolls in succession WELDING VOLTAGE ( ) - ELECTRONIC INDUCTANCE (
VISION S
(this operation is activated when the key is released).
CREEN
Adjusts the parameter selected using the DX K
PARAMETER DISPLAY Screen - V
0.0s (0.0 - 5.0)s
0 -30 - +30
1.0s (0.0 - 10.0)s
0.05s (0.0 - 1.0)s
5.0m/min (0.6 - MAX)m/min
25.0V (min - MAX)V
0.05s (0.0 - 1.0)s
100A/s (5 - 500)A/s
V
m/min
7.8 31.3
35
Welding mode
●
● ● ● ●
● ● ● ●
● ● ● ●
MIG-MAG manual
ENTER/MEM K
EY
DX K
EY
ENCODER K - DX
NOB
VISION S
CREEN
.
EY
.
EY
● ● ● ●
● ● ● ●
●
● ●
● ●
●
● ● ● ●
) only on